Infocus INF5520 User Manual

009-1420-00*009-1420-00*PhotoBooth Setup Guide

PhotoBooth Assembly Page 9 3. Attach the flash unit to the half pole using the knurled clamp screw. Tighten securely. 4. Slide the half pole

Page 10 PhotoBooth Assembly Attaching the Pivot Arm 1. Insert the stud into the super clamp and attach the super clamp securely to the pivot ar

PhotoBooth Assembly Page 11 Preparing the Camera Note: For this section, you will need the Canon AC adapter kit, the Canon camera, camera lens an

Page 12 PhotoBooth Assembly 7. Attach the camera to the pivot arm securely. 8. Carefully loosen the pivot arm adjustment knob to make final adju

PhotoBooth Assembly Page 13 Preparing the Wireless Trigger 1. Slide the battery door off. 2. Insert a 12V battery into the wireless receiver, b

Page 14 PhotoBooth Assembly Taking a PhotoBooth Photo 1. Turn Mondopad ON. 2. Turn the camera’s power switch to ON and the Mode Dial to M (“Man

Framing Images Page 15 Framing Images 1. From the Mondopad home page, navigate to View & Share. 2. Open an image file. Note: Images created

Page 16 Framing Images 7. Tap Frames from the menu. 8. Tap the frame you want for the image and tap OK.

Framing Images Page 17 9. To save the image, tap Save JPG. 10. Type a name in the File Name field and tap Save. 11. Saved images can be viewed

Page 18 Framing Images Note: Saved images can also be found in the following folder: Documents>Mondopad Documents. Adding New Frame Files to

IMPORTANT NOTES PhotoBooth is a combination of various manufacturer items, such as the camera and light. Please read all manufacturer documentation

Framing Images Page 19 Note: For best results, PNG images should be the same resolution as the Mondopad (1920 x 1080) and have transparent centers

Page 20 Accessing additional documentation Accessing additional documentation To complete the setup of this product and the Mondopad Collaboratio

Troubleshooting Page 21 Troubleshooting The following table is meant to assist you with troubleshooting your PhotoBooth. It is not a comprehensiv

Page 22 Troubleshooting  Verify that the camera power switch is turned on.  Turn the camera off and on again.  Verify that the camera’s SD m

Contents IMPORTANTNOTES...

Accessory Identification Page 3 Accessory Identification Speed Ring Super Clamp Half Pole 18-30” (46-74cm) Pivot Arm with Camera Bracket

Page 4 Accessory Identification The accessories which you receive depend upon the part number you ordered: INF-5520-PB-C INF-PBKit-NOMP AC Adapt

PhotoBooth Assembly Page 5 PhotoBooth Assembly PhotoBooth PC Module Installation If you ordered INF-PBKit-NOMP, you will need to follow these ins

Page 6 PhotoBooth Assembly 2. Attach the speed ring to the flash unit by aligning the slots of the speed ring to the front of the flash unit and

PhotoBooth Assembly Page 7 4. Insert the cable ends into the speed ring. 5. Secure the Velcro at each corner of the softbox to complete its rec

Page 8 PhotoBooth Assembly NOTE: If your mobile cart does not have holes drilled into it as per below, please contact InFocus Support at: www.info