Infocus IN5122 User Manual download pdf (Page 17)

ENGLISH

HIGH VOLTAGE

HIGH TEMPERATURE HIGH PRESSURE

WARNING ►The projector uses a high-pressure mercury glass lamp. The

lamp can break with a loud bang, or burn out, if jolted or scratched, handled

while hot, or worn over time. Note that each lamp has a different lifetime, and

some may burst or burn out soon after you start using them. In addition, if the

bulb bursts, it is possible for shards of glass to y into the lamp housing, and

for gas containing mercury and dust containing ne particles of glass to escape

from the projector’s vents.

►About lamp disposal: This product contains a mercury lamp; do not put it in

the trash. Dispose of it in accordance with environmental laws.

• For lamp recycling, go to www.lamprecycle.org (in the US).

• For product disposal, consult your local government agency

or www.eiae.org (in the US) or www.epsc.ca (in Canada).

For more information, ask your dealer.

• If the lamp should break, unplug the power cord from the outlet, and

make sure to request a replacement lamp from your local dealer. Note

that shards of glass can damage the projector components, and cause

injury during handling, so please do not attempt to clean the projector or

replace the lamp yourself.

• If the lamp should break, ventilate the room well, and make sure not to

inhale the gas or ne particles that come from the projector's vents, and

get them into your eyes or mouth.

• Before replacing the lamp, turn the projector off and unplug the power

cord, then wait at least 45 minutes for the lamp to cool sufficiently.

Handling the lamp while hot can cause burns, as well as damage to the

lamp.

• Never unscrew screws except those marked by an arrow.

• Do not open the lamp door while the projector is suspended from

a ceiling. This is dangerous, since if the lamp’s bulb has broken, the

shards will fall out when the cover is opened. In addition, working in

high places is dangerous, so ask your local dealer to have the lamp

replaced even if the bulb is not broken.

• Do not use the projector with the lamp door removed. When replacing

the lamp, make sure that the screws are screwed in firmly. Loose

screws can result in damage or injury.

• Only use specied lamp types. Using a lamp that does not meet the lamp

specications for this model can cause a re, projector damage or shorten

the life of this product.

• If the lamp breaks soon after the first time it is used, it is possible

that there are electrical problems elsewhere besides the lamp. If this

happens, consult your local dealer or service representative.

•

Handle with care: jolting or scratching could cause the lamp bulb to burst during use.

• Using the lamp for long periods of time can cause the lamp to be dim,

not to light up or to burst. When the pictures appear dim, or when the

color tone is poor, please replace the lamp as soon as possible. Do not

use old (used) lamps; this can cause breakage.

Disconnect

the plug

from the

power

outlet

Replacing the lamp (continued)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

Comments to this Manuals

No comments

Infocus IN5122 User Manual Page 17

Comments to this Manuals

Related products and manuals for Data projectors Infocus IN5122