Infocus HW-DIRECTOR-2 Datasheet download pdf

This document describes how to make your InFocus remote control produce

commands that may not be directly available as buttons on the remote.

These commands are intended to be used by 3

party ‘learning’ remotes that

can learn codes from other remotes.

For example, by using these modes, you could program a 3

party remote to

produce a ‘discrete power on’ command as part of a macro used to turn on all of

your A/V devices, and then produce a ‘discrete power off’ command as part of

another macro that turns off all of your A/V devices.

Your remote supports three different modes for producing additional

commands. Each mode reconfigures the buttons on the remote to produce a

different set of commands; refer to the table below to find out which commands

and modes you’ll need.

Example: To make your remote produce the ’16:9 Aspect Ratio’ command:

1) Look up ’16:9 Aspect Ratio’ in the table below; it is produced when you press

the Auto Image button while the remote is in mode 3.

2) Enter mode 3 by holding down the Presets button on your remote for 10

seconds.

3) Press the Auto Image button on your remote to produce the ‘16:9 Aspect

Ratio’ command.

4) Exit mode 3 and return to normal remote operation by holding down the

Presets button on your remote for 10 seconds (or wait 2 minutes for the

remote to automatically exit the mode).

NOTE: Information in this document applies to the following

InFocus remote control models:

HW-NAVIGATOR-3

HW-DIRECTOR-2

HW-COMMANDER-2

1 2

Page 1

This document describes how to make your InFocus remote control produce commands that may not be directly available as buttons on the remote. These

Page 2

Enter the mode by holding down a button on your remote: To enter mode 1: To enter mode 2: To enter mode 3: Hold down the Custom button on the remote

No comments

Infocus HW-DIRECTOR-2 Datasheet