Infocus SP-CEIL-003 User Manual download pdf (Page 2)

q Step 5

Install the two (2) conical spacers (J) and two (2) flat washers (K) two

(2) hinge pin screws (L) loosely on both sides of the base box (H).

Raise the projector with the mounting bracket attached and slip though

the hinge pin slots openings on the bracket into the base box. Install the

two (2) angle locking screws (I) adjust the angle, lock it, and then

tighten the hinge pin screws (L).

See Figure 3

Check all hardware for proper tighten and security.

The ceiling should be capable of supporting a weight of

at least five (5) times the weight of 45 Lbs. If it cannot, the

ceiling must be reinforced. Proper installation procedure

by qualified personnel as outlined in the installation

instructions must be adhered to. Failure to do so could

result in serious personal injury.

DESCRIPTION/HARDWARE

A. 8 (mm) x 10 (mm) Phillip Screws (6ea)

B. SP -CEIL-003 Mounting Bracket (1ea)

C. Projector (Not Supplied)

D. Projector’s Feet

E. Projector Lens

F. Suitable Hardware (Commercially Available)

G. Ceiling Structure (See Warning Label)

H. Base Box/Jam Nut (1ea)

I. 6 (mm) x 12 (mm) Angle Locking Screws (2ea)

J. Conical Spacers (2ea)

K. Flat Washers (2ea)

L. 6 (mm) x 12 (mm) Hinge Pin Screws (2ea)

M. SP-LTMT-EXT Adjustable Suspension Adapter

N. Suspension Adapter Adjustable Pins (2ea)

27700B S.W. Parkway Ave.

Wilsonville, Oregon 97070-9215

Phone 1-800-294-6400 Fax

www.infocus.com

For further information or ordering assistance

on the front of this page.

1 2

No comments

Infocus SP-CEIL-003 User Manual Page 2