Infocus IN2128HDA User's Guide download pdf (Page 59)

1 Turn off the projector and unplug the power cord.

2 Wait 60 minutes to allow the projector to cool thoroughly.

3 Remove the lamp door, located on top of the projector, by removing the

screw on the side of the lamp door, sliding the door forward, and lifting the

lamp door off.

4 Loosen the captive screws that attach the lamp housing to the projector.

NOTE: If the projector is installed on a ceiling mount, be careful not to drop

the lamp module once the captive screws are loosened.

5 Carefully lift the lamp straight up, off of the alignment pins; being careful not to

pinch the lamp connector. Dispose of the lamp in an environmentally proper

manner.

6 Install the new lamp module, aligning the pins properly. Be careful not to pinch

the lamp connector.

7 Tighten the screws. (NOTE: If the pins have not been aligned properly, the

screws will not tighten securely.)

8 Replace the lamp door by (a) aligning the hinges, (b) putting the lamp door

down and (c) locking it back into place.

9 Replace the lamp door screw and tighten securely.

10 Plug in the power cord and press the Power button to turn the projector back

on.

11 To reset the lamp hour timer, navigate to the Advanced Menu > Status/Service

menu and select Reset Lamp Hours....

turn off and unplug

projector

wait 60 minutes

loosen screws

Image

Setup

Status/Service

Basic Menu

Source Info

Projector Info

Reset Lamp Hours

Factory Reset

Service Code

( Advanced Menu )

MDL: IN2128HDa

FW: X.XX

1 2 ... 54 55 56 57 58 59 60 61 62

No comments

Infocus IN2128HDA User's Guide Page 59