Infocus SP8600 User Manual Page 42

  • Download
  • Add to my manuals
  • Print
  • Page
    / 51
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 41
SP8600 User's Manual
35
LED Error Messages
ERROR CODE MESSAGES
POWER LED
BLINK
LAMP LED
BLINK
TEMP LED
BLINK
Lamp Ready ON ON OFF
Start (AC Power standby) ON OFF OFF
Cooling ON flashing OFF
Over Temperature OFF OFF ON
Thermal Break Sensor error 4 blinks 4 blinks OFF
Lamp error 5 blinks OFF OFF
Lamp End of lamp life detected 5 blinks 3 blinks OFF
Burner Fan error 6 blinks 1 blinks OFF
Lamp Fan error 6 blinks 2 blinks OFF
Power Fan error 6 blinks 3 blinks OFF
DMD Fan error 6 blinks 4 blinks OFF
Case Open 7 blinks OFF OFF
DMD error/ Ignition failed 8 blinks OFF OFF
Color wheel error 9 blinks OFF OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the POWER or LAMP LEDs are still blinking or the TEMP LED is lit, contact
your service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control or projector.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Installation I menu of the OSD.
Problem: The image is streaked
1. Set the Frequency and Tracking settings on the Computer menu of the OSD to the de-
fault settings.
2. To ensure the problem is not caused by a connected PC’s video card, connect to another
computer.
Page view 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 50 51

Comments to this Manuals

No comments