Infocus SP8600 User Manual download pdf (Page 4)

Preface

Projector Installation Notice

¾ Place the projector in a horizontal position

The tilt angle of the projector should not exceed 15 degrees, nor should the projector be installed in

any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically.

¾ Allow at least 50 cm clearance around the exhaust vent.

¾ Ensure that the intake vents do not recycle hot air from the exhaust vent.

¾ When operating the projector in an enclosed space, ensure that the surrounding air temperature

within the enclosure does not exceed 5 – 35°C while the projector is running, and the air intake and

exhaust vents are unobstructed.

¾ All enclosures should pass a certified thermal evaluation to ensure that the projector does not

recycle exhaust air, as this may cause the device to shut down even if the enclosure temperature is

within the acceptable 5 – 35°C range.

Power Safety

¾ Only use the supplied power cord.

¾ Do not place anything on the power cord. Place the power cord where it will not be in the way of

foot traffic.

¾ Remove the batteries from the remote control when storing or not in use for a prolonged period.

– iii –

1 2 3 4 5 ... 51

No comments

Infocus SP8600 User Manual Page 4