Infocus PRJ-LIFT-UNIV Installation Manual download pdf (Page 9)

Installation Instructions SL220

WARNING: IMPROPER INSTALLATION CAN LEAD TO

LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR

DAMAGE TO EQUIPMENT! It is the installers responsibility

to make certain the structure to which the lift is being

mounted is capable of supporting five times the weight of the

lift and all attached equipment. Reinforce the structure as

required before installing the lift.

NOTE: The following instructions assume a suitable mounting

structure and surface exists prior to installation and all

power and signal wires and cables have been properly

installed.

Electrical Rating

100-250VAC~, 50/60Hz, 960W

North America: 120VAC, 60Hz, 8A

IMPORTANT ! : This product must be grounded. If it should

malfunction or break down, grounding provides a path of least

resistance for electric current to reduce the risk of electric

shock.

Grounding Instructions

This product must be connected to a grounded metal,

permanent wiring system, and must be properly installed and

grounded in accordance with all local codes and ordinances.

This product is suitable for use in Other Environmental Air

Spaces in Accordance with Section 300.22(C) of the National

Electrical Codes, 2008.

WARNING: RISK OF ELECTROCUTION! All electrical

wiring required for installation should be installed by a

qualified electrician.

IMPORTANT ! : The appropriate outlet being installed must

be the grounding type and properly grounded in accordance

with all local codes and ordinances.

3. Wire outlet into junction box in accordance with all local

codes and ordinances.

PREPARING THE SL220

Carefully inspect the SL220 for any shipping damage. If any

damage is apparent, do NOT continue with the installation.

Instead, contact Chief for further instructions.

Removing Ceiling Pan

1. Place SL220 upside down on clean surface.

NOTE: The SL220 is shipped with the ceiling pan

disconnected, but in place.

2. Remove ceiling pan and set aside.

Installing IR Sensor and Power Cord

The IR sensor placement is crucial to proper operation of the

SL220.

1. Plug IR sensor (S) into control box. (See Figure 10)

NOTE: The final location of the sensor won’t be made until

after the SL220 is installed into the ceiling.

Figure 10

Front of

SL220

Plug in IR

Receiver

(Some parts

for clarity)

removed

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments

Infocus PRJ-LIFT-UNIV Installation Manual Page 9

Comments to this Manuals