Infocus DISPLAY LINK IN3902LB User Manual download pdf (Page 16)

Buttons and Wand Tip

The wand's three top buttons are equivalent to the left (labeled 'L'), right

(labeled 'R'), and middle (labeled 'M') buttons on a mouse. The wand's tip is

also a button, and it's also equivalent to the left mouse button. NOTE: By

default, the M button changes wand motion between Normal and Draw.

Normal makes clicking easier, but Draw allows smoother motion. You can

change the M button to perform other functions, including a standard

middle button mouse click (see LiteBoard Wand Menu below).

Battery Light

The amber battery light shows the status of the

wand's built-in battery (see

below for battery information). The battery light will turn on while the

wand is charging, and it will blink if the battery is low (2-4 hours of wand

use left).

Link Light

The green link light shows the status of the wand'

s wireless connection to

the projector. The link light will blink frequently (more than once per

second) when the wand is attempting to link to the projector; then it will

blink less frequently (about once every 4 seconds) after the wand has linked

to the projector. NOTE: The link light will stay off when the wand is off.

USB Connector

The wand's USB connector is

behind a flap on the back of the wand. The

USB connector is only used for charging the wand's battery - using the

included USB power adapter, or a computer. NOTE: You can use the wand

while charging the battery, but after the battery is charged (battery light

turns off), you can unplug the USB cable and continue to use the wand

without a cable.

Sensor

The wand's optical sensor opening is located

above the wand's tip. Don't

block the sensor, and make sure it always has a clear view of the screen.

NOTE: The sensor won't work if you point it at a shadow or away from the

screen.

Reset Button

The wand has a reset button, behind a smal

l hole on its underside. Under

normal conditions, you should not need to reset the wand. See the

Troubleshooting section below for more information.

Internal Radio

The wand has a built-in wireless transmitter/receiver which it

uses to

communicate with the projector.

Lithium Battery Information

Manufacturer: KAYO Battery (ShenZhen) Co., Ltd.

Model: ICR14430

Rating: 3.6VDC/650mAh

Caution: Li

thium battery is only rechargeable, and not user replaceable. Not

user serviceable.

LiteBoard Wand Menu

You can access the LiteBoard Wand menu from the projector's Setup menu.

To change the settings in this menu, highlight a setting, then press Select (on

the projector or its remote) one or more times - each press of Select will

change to the next value for the setting.

Enabled:

controls whether the projector lets you use LiteBoard Wands. Set

this to Yes to allow wand use. Set this to No to prevent wand use.

1 ... 15 16 17 ... 51

Comments to this Manuals

No comments

Infocus DISPLAY LINK IN3902LB User Manual Page 16

Comments to this Manuals

Related products and manuals for Projectors Infocus DISPLAY LINK IN3902LB