Infocus IN5122 User Manual download pdf (Page 11)

Setting up

Connecting with your devices

Before connecting the projector to a device, consult the device’s manual to

conrm that the device is suitable for connecting with this projector and prepare

needed accessories, such as a cable in accordance with the signal of the device.

Consult your dealer if any needed accessories did not come with the product or if

the needed accessory is damaged.

After verifying that the projector and the devices are turned off, make the

connection, according to the following instructions. Refer to the illustrations on

subsequent pages.

Before connecting the projector to a network system, be sure to read the Network

Guide too.

►Only use appropriate accessories. Otherwise they may

cause a re or damage the projector and devices.

• Only use accessories specied or recommended by the projector’s

manufacturer. They may be regulated under some standard.

• Do not disassemble or modify the projector or the projector’s accessories.

• Do not use damaged accessories. Be careful not to damage the accessories.

Route a cable so that it cannot be stepped on or pinched.

WARNING

►If the cable only has a core at one end, connect the end

with the core to the projector. This may be required by EMI regulations.

CAUTION

• Plug-and-Play is a system composed of a computer, its operating system

and peripheral equipment (i.e. display devices). This projector is VESA DDC

2B compatible. Plug-and-Play can be used by connecting this projector to a

computer that is VESA DDC (display data channel) compatible.

- Take advantage of this feature by connecting a computer cable to the

COMPUTER IN1 port (DDC 2B compatible). Plug-and-Play may not work

properly if any other type of connection is attempted.

- Please use the standard drivers in your computer as this projector is a Plug-

and-Play monitor.

• The feature of some of the input ports can be selected based on your usage

requirements. Refer to the page number indicated beside each port in the

following illustration.

• Be careful not to mistakenly connect a connector to an incorrect port.

Otherwise it may cause a device or projector malfunction.

When connecting a connector to a port, make sure that the shape of the

connector ts the port.

- Tighten the screws to connect a connector equipped with screws to a port.

- Use cables with straight plugs, not L-shaped ones, as the input ports of the

projector are recessed.

About Plug-and-Play capability

NOTE

(continued on next page)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 96 97

Comments to this Manuals

No comments

Infocus IN5122 User Manual Page 11

Comments to this Manuals

Related products and manuals for Data projectors Infocus IN5122