Infocus IN3926 Specifications download pdf (Page 33)

Controlling the projector through a LAN

environment

The projector supports Crestron

software. With correct settings for the Network

menu, you can manage the projector from a computer using a web browser when

the computer and the projector are properly conn

ected to the same local area

network.

Wired connection

Internet

IP Router

Configuring the LAN control setting

If you are in a DHCP environment:

1 Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the

projector and the other end to the RJ45 port .

2 Press Menu on the keypad or remote and then go to Advanced Menu > Setup

> Network menu.

3 Press v to highlight DHCP and press < or > to select On.

4 Press v to highlight Apply and press >.

5 Please wait for around 15 - 20 seconds, and then re-enter the Network page.

The IP address, Subnet Mask, Default Gateway, DNS and Mac Address

settings will be displayed. Write down the IP address displayed in the IP

addr

ess row.

• If the Projector IP Address still does not display

, contact your network

administrator.

• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,

Default Gateway, DNS and Mac Address settings will display 0.0.0.0. Make

sure the cables are properly connected and perform the procedures above

again.

• If you need to connect to the projector in its standby mode, set the Power

Saving Mode feature to Off.

If you are in a non-DHCP environment:

1 Repeat steps 1-2 above.

2 Press v to highlight DHCP and press < or > to select Off.

3 Contact your network administrator for information on the IP address, Subnet

Mask, Default Gateway, DN

S and Mac Address settings.

4 Press ^ or v to select the item you want to modify.

5 Press < or > to move the cursor and then press ^ or v to select the value.

6 Press v to highlight Apply and press > to save the settings.

• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,

Default Gateway, DNS and Mac Address settings will display 0.0.0.0. Make

sure the cables are properly connected and perform the procedures above

again.

• If you wish to connect to the projector in its standby mode, be sure to select

RJ45 and obtain the IP Address, Subnet Mask, Default Gateway, DNS and

Mac Address information when the projector is on.

1 ... 32 33 34 ... 51

Comments to this Manuals

No comments

Infocus IN3926 Specifications Page 33

Comments to this Manuals

Related products and manuals for Data projectors Infocus IN3926